SALES - SERVICE - REPAIR
CUSTOM CONSTRUCTION - DESIGN & INSTALL
Sacramento Sauna
*** authorized dealer for ***
Finnleo // Sauna360 Inc
OPEN WEDNESDAYS & FRIDAYS 12-6pm
SATURDAYS 10AM to 2PM
CALL US FOR WED/FRI/SAT EXTENDED HR APPOINTMENTS
8836 GREENBACK LANE, ORANGEVALE CA 95662
*APPOINTMENTS RECOMMENDED FOR ALL CUSTOM SAUNA PROJECTS*
Supplying power to your indoor sauna
Finnleo Hallmark & Designer Models - 240 Volt
HM46 / HM57 / HM55 / HM66 / Designer models
Sacramento Sauna recommends using a licensed electrical contractor for electrical alterations required to supply 240 volt power to your new sauna’s location. We can supply your electrician with the specifications they need for your chosen sauna model or you can use our approved independent electrical service co. They are familiar with sauna installations.
It is our standard practice to have the electrician install a
240 volt receptacle for use on the 240 volt saunas listed
above. When we install the sauna, a corresponding plug and
custom fit cord are included with the install process.
The receptacle used is shown here as it should be installed
in the wall with ground terminal up. Location of the
receptacle is typically behind the sauna but if the sauna
cannot be easily moved then space behind the
sauna to remove the plug from the receptacle should be
considered.
The location of the power cord where it enters the sauna
is typically at the back and bottom right side.
120 Volt - 15A
HM44 / S810 IR / S820 IR
These saunas are designed to be able to be plugged into standard household receptacles which have a maximum deliverable loads of approximately 1800 watts. All of our 15 amp sauna models will use most or all of that amount of wattage. For example an HM44 will require 1700 watts of power to perform well. Having a qualified electrical contractor check for any load issues can often cure any deficiencies that may arise such as a bad circuit breaker, loose connections somewhere in the circuit or a loose receptacle you are plugging the sauna into.
​
120 Volt - 20A
HM44 / S825 IR / S830 IR / S840 IR / S870 IR / S880 IR
Homes are typically wired with 15 amp circuits. If you
are planning to use one of the above models you will
need to have an electrical contractor install a 20 amp
circuit for use with the sauna. If you are planning to
use the sauna in a garage it may already be outfitted
with 20 amp receptacles. As with the 15 amp models,
20 amp saunas will use all or most of the circuits
2400 watt delivery. For that reason, it is important to
consider installation of an additional dedicated circuit.
SACRAMENTO SAUNA SUPPLY / 530-308-2359
Sauna Lifestyle Products


